Home   |  Shop   |  View Cart  |  Checkout   |  Services    |  Contact us   |  Tell a Friend  
TM793.3M Cord Use the 15 foot 3M cord to connect ESD tabletop and floor mats to a building ground. The solderless terminal can be connected to an electrical outlet using the screw in the outlet cover.
  • USES: To connect ESD mats to a building ground
  • CONSTRUCTION: Molded-in male snap fastener on one end and solderless terminal on the other
  • RESISTIVITY: Integral one megohm resistor
  • SNAP: Conforms to 10mm snaps


    TM797.CP CORD A 15 foot cord equipped with dual jacks. This common point ground cord allows two wrist straps to be grounded at the same point. The molded-in male fastener snaps to table-top mats while the solderless terminal at the end of the 15 foot cord connects to a building ground.
  • USES: To achieve a common ground with the building,table-top mat and wrist strap
  • CONSTRUCTION: Molded-in male snap fastener with two sockets to accommodate banana jacks
  • RESISTIVITY: No resistor necessary
  • SNAP: Conforms to 10mm snaps

    TM793.6WStrap Grounds workers to their ESD tabletop mats. To complete the conncection to a building ground,connect the coil cord to our 797.CPCord or simply clip to the grounding snap.
  • USES: To ground the Worker to the mat.
  • CONSTRUCTION: One inch wide comfort strap with copper sulfide fibers,6 ft. Coil Cord with snap on one end and a banana jack on the other. Separate alligator clip
  • RESISTIVITY: One megohm resistor
  • SNAP: Conforms to 10mm snaps
    		•  Heel Ground
    Width 1-1/2"
    Price Each
    Size: w/One Megaohm Resistor
    Capacity:
    		Weight: 1 Lbs.

    Shipvia: UPS

    Unit: 1 / Ea

    List: $13.00     		Item#:
    TM793.HG

    Buy